Back to main product

Adix > Products > Wear Detector
Wear detector, component of the Adix NOVEx and NOVEx II explosion isolation flap valves

Wear Detector

Accessory designed to detect abrasion wear on the NOVEx flap valve caused by the continuous flow of product through the duct.

This product is not available for purchase in every country (please inquire)

Accessory designed to detect abrasion wear on the NOVEx flap valve caused by the continuous flow of product through the duct.

It is installed at the bottom of the valve, replicating the wear conditions of the flap. When wear reaches a critical level, the sensor interrupts the signal.

*Installation requires an intrinsic safety barrier.

  • NAMUR inductive sensor, suitable for ATEX zones
  • Normally closed
  • Sensing distance: 0.04″ (1 mm) (±10%), flush mounting
  • Thread: M12x1 mm
  • Cable: 6.6 ft (2 m), PVC, 2 x 0.14 mm²
  • Operating temperature: -4 °F to 176 °F (-20 °C to 80 °C)
  • Degree of protection: IP67
  • ATEX marking: II 1G Ex ia IIC T6 Ga Ta -20…70°C / II 1G Ex ia IIC T5 Ga Ta -20…80°C II 1G Ex ia IIC T5 Ga Ta -20…80°C / II 1D Ex ia IIIC T200 90°C Da Ta: -20…70°C II 1D Ex ia IIIC T200 90°C Da Ta: -20…70°C / II 1D Ex ia IIIC T200 100° C Da Ta: -20…80°C II 1D Ex ia IIIC T200 100° C Da Ta: -20…80°C

Have a question?

Contact us and our engineering team will get back to you.